Floor Jack 3.5 Ton

The NAPA Professional Lifting Equipment’s 3.5 Ton Service Jack, No. 791-6420, features a two-year, no-hassle replacement warranty and has a nationwide service center network for a long life of service. Weighing in at just under 100 lbs, it features a beefy flanged side-plate design to resist twist force that can occur when lifting loads on uneven surfaces. The sealed twin-piston pump, coupled with its padded, 50” handle, controls loads to a maximum lifting height of 20.5” and rests at a 4” low height. This jack features a removable saddle and saddle pad for use with transmission adapter, No. 791-7130, and is ASME PALD 2009 safety-compliant. Steel Jack chassis with reinforced upper and lower side frame flanges for extra strength and more stability under torsion loads 4” to 20-1/2” lift range handles most vehicle applications Fabricated steel lift arm with fitting to lubricate the main pivot pin Full factory lubrication with moisture-resistant grease on all bearing surfaces. Removable saddle with full cover rubber saddle pad protects vehicle frame from being scratched or marred Rear swivel ball bearing mounted caster wheels and large diameter front wheels for easy maneuverability 50” two-piece quick connect/disconnect steel handle halves with rubber pad for bumper protection and knurled end for better hand grip Hydraulic power unit includes: Fully sealed reservoir which significantly reduces air bound conditions Two pump pistons for 50% faster lift arm raising to the load, and dust shields to prevent contaminants from entering the hydraulic system High performance pressure seals for extended jack life and use in adverse temperature and pressure conditions High performance hydraulic fluid with additives that provide more lubricity, less contaminants and use in adverse temperature conditions. Load-limiting and bypass safety valves prevent the jack from being used beyond its capacity range and over extension of the main ram